Jump to content

Petsvo

Members
  • Posts

    36
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Petsvo's Achievements

  1. I am following the switch and the switch on sequence in the manual. I am taking it out and sending it to Sunsynk repair centre so that they can check it up
  2. If you check the pics, its not in normal mode, the BMS is running perfectly. The only setting i changed was the 74amps on the battery settings.
  3. They were no faults before the rest.
  4. Can that cause the System not switch the load on .
  5. I have just resetted it this are my new pics:
  6. I finally got my sunsynk running it has been running for months now, but yesterday it just cut the power off. Battery Soc is at 85%, Grid is on, the PVs are on. All settings have not been changed but it cant go on Normal Mode, what could the problem
  7. The least I can say is that this is not an efficient inverter because it can only run lights with 2 pylons . I can't even run a fridge or microwave for a minute, and my borehole is even worse because it can't be run with the inverter it will trip. I've followed all of the advice and will rather install my MKSii Axpert/ Meccer back. In my opinion, this is an overrated product very unstable
  8. attached is my battery shutdown page, hope those are the correct settings
  9. This is my grid setup page, hope it's the right one.
  10. Yes, I have two Pylontechs. I set the top one to be the master, but I'm not sure what the deep switch settings are. The batteries are charging differently, as you can see, the top one has three bars and the bottom one has two. Last night, no battery was charged when power was restored, so I'm guessing it's set to USE Timer on the Inverter Mode. The battery photo is attached. Please let me know if you think this is where I'm going wrong..
  11. The below are the menu pics, when grid power goes off the inverter takes 3min switch the load is that normal, and in general it cant run a fridge or borehole .75kw, it will throw error F56 and cuts off, then wait for more 3min to comeback and switch the load, my old Meccer was just seconds to switch from Grid to Battery or vice versa.
  12. thanks, but the inverter more that 3 minutes to power the load, is that normal, i am getting F56( low voltage error) batteries are fully charged, my load is around 2.5 kw the inverter cant run for more than 10 min.
  13. I haven't connected the PVs yet; I just want to configure the AC and batteries first. I have two pylontech 3000c batteries, i just want to resuscitate power after knocking off the old inverter; what is the recommended setting on these batteries? I was using the first generation Meccer 5kva inverter inverter and had not setup master slave; I need to do that on these batteries as well. I had the idea that you could have a simple option to choose battery manufacturer but its not there.
  14. I haven't connected the PVs yet; I just want to configure the AC and batteries first. I have two pylontech 3000c batteries, i just want to resuscitate power after knocking off the old inverter; what is the recommended setting on these batteries? I was using the first generation Meccer 5kva inverter inverter and had not setup master slave; I need to do that on these batteries as well. I had the idea that you could have a simple option to choose battery manufacturer but its not there.
×
×
  • Create New...