ozzy71

Hi All ,

(Not sure if this is the correct place/thread/forum to ask this question)

How can i change the initial acceleration on this EV tricycle's throttle, from standing still to first movement?

Can i add a capacitor/resistor in order to decrease the quick acceleration when the throttle is barely touched. I want the bike to slowly creep a bit first before ramping up the speed . . it is difficult to manoeuvre the bike slowly when driving in confined spaces . . it jumps forward immediately even when the throttle is slowly twisted for a millimeter.

It feels as if the speed stays the same if the the throttle is held in the same place ,the tricycle is on a farm at the moment, in storage.
We bought it brand new, to move compost and plants around in a garden on the farm, but it is very difficult to manoeuvre the tricycle slowly through small pathways and past curving flower-beds as the slightest twist of the throttle shoots the tricycle quickly forward, although you then move at a slow speed if the throttle is barely twisted.

This is what i could find in the manual that came with the TailG Tricycle:

It says in the manual hub-motor but it is a motor that is situated in the middle of the axle (equally far apart from the two rear-wheels, where the diff is, just an external electric motor that drives the axle shaft)

Model:TL1500DZH-5A

See attached pics also.

I hope this helps.

The bike has a low and normal speed, but the initial acceleration on both speeds are the same . . .is there a way to restrict the initial voltage that goes from the 0-5V potentiometer (5k Ohm) ?

Here is what the throttle and potentiometer looks like....attached.

Thank you in advance !

If you use CAN on the Inverter and make sure you use the cable that came with the A48100 for Deye/Sunsynk it will work with no additional config.