Ash124

Hello, thanks for the responses. I did a few changes to the setup, I started supplementing the solar power from the battery during the day and it works perfectly. Drops the SOC to the right levels etc. I changes the SOC from 20% to 15% in the mornings when the geyser turns on. This worked perfectly for a few days then the powering from the battery stopped at 16%, then 17% and today at 20%. Even though its set to discharge to 15%. I don’t know if its the load in the morning that doesn’t allow it to discharge to a consistent set SOC of 15%. Any suggestions/questions?

Good morning, feedback after ticking grid. Switches to grid at 28%, instead of when SOC reaches 20%.

Thank you @Scorp007 I will try this. I unselected sync for the time and it worked for a few mornings but since 3 mornings ago, it would only power down the batteries to 21%, 22% and 25% (this morning) instead of 20%.

@Scorp007 Please find timer settings attached. @esmail-kassir When I change the last time to 23:55 (it doesn’t allow 23:59). It changes the next time frame to start at 23:55 and not 00:00. Seem like there should not be a gap in time. Thank you

Good day, I removed sync and sadly, the power still switched to grid although SoC was set to 20%. Please advise on any other thoughts. Thanks you

Thank you for the prompt response. The clock is manually set with the sync option selected.

Good day, I have a 8kw sunsynk invertor with 2 x 5.12kw batteries, with 8 solar panels. I had my timer setup to use the batteries between 05:00 and 07:30 to 20%. However, of recent, it stops using the batteries at around 6:00 to about 42% and switches to grid. I have changed the timing thinking maybe that time slot is acting up but no luck. Please help.