zak2021

@Scorp007 Yes I also suspect that my banks are not getting fully charged due to incorrect settings Will send updated logs and monitor after a few days with the new settings in place.

Hi rechecking if this is now correct ive attached the manual and some screen shots At C10 , i should be able to draw 15AMP for 10HOURS I am not drawing any where close to that atm, from my logs, i'm drawing around 7AMPS from the discharge table, at 10hours its 15 AMPS X 4 = 60AMP DISCHARGE Setting SP12-150.pdf

Good evening Gents I seem to be having some issues with my setup. My system is shutting down with SOC at 80% I have 4 x 4 150AMPs AMG batteries ( total 600APH ) Firstly Ive set the battery capacity to 150amps. Is that the correct setting? Or should it be the total capacity of the bank which is 600 amps 2) Using the table provided in this thread, Ive used 48V at the shutdown which suppose to give me around 50% of battery life the voltage is around 48ish , system shuts down, and then around 2 mins later boots back up again. However SoC is around 80%. I am confused what is happening here. Need to revalidate my settings. Some help here please Pictures attached will show , SoC at 80 Percent, load is small under 1kw. I should be getting alot more out of this setup. However its only lasting me 1.5 hours before it shuts down Its been happening more frequently as of late

thanks guys appreciate the help. i am starting to understand how these settings work My last question would be What is the purpose of the "Discharge Amps" Setting on the system. What would be an appropriate value?

Good morning, I just upgraded our system from an old ups system with 16 AGM 12V 150AH batteries to the synsynk 8kw system. Everything is up and running. I need some help with the battery settings on the synsynk. Ive attached screenshots of the current settings. Im not sure if these are correct or not. I appreciate it if someone who has knowledge about this could help me configure this properly thanks Zak

solarway from jhb

any installers in durban to install 2 systems Zak

Here is the battery

Hi I saw an add from the sunshop, selling lituim ion batteries quite reasonably and I bought one. Spoke to the guy and said it will work with the sunsynk 5kva hybrid. Purchased both and I see there no coms cable. Called them and I'm getting the run around. Is the coms cable for these batteries a normal ethernet cable? Secondly do you need a CT coil on the grid side? What if you want to feed it back it the grid as a grid tie in system? From what I read the CT coil stops the export of excess energy back into the grid. AM I correct in that understanding? Lastly looking for someone who can help advice my electrician for the overall setup and troubleshooting I'm based in Durban Thanks Zak