Shaunj187za

WANTED: Mecer BBONE 2400 (Chassis Only) aka Mecer 2.4KVA 1440W Housing Looking for a chassis that my LOBO inverter can fit into

Good Day All I have been using the Mecer SOL-I-AX-1VP/3VP/5VP for years with AGM Batteries, Never Any issues. Now i have started to pair them with the Vision SOL-B-L-V200-12V & Mecer SOL-B-L-M200. I have set the correct Bulk/Float/Cut Off voltages for each of these lithium type batteries. I have connected the inverter with the WATCH POWER SOFTWARE it ships with and it says batteries are 100% Charged but every 10 minutes. The fan comes on and starts recharging the batteries. There is no load on the unit but the fans go on and off all days irrespective of what values i put in. On the AGM batteries i only ever hear the fan during load shedding when the unit is being used or when the power is back on and the unit is charging. Is this normal when paired with lithium batteries?

@Riaanh do you currently have the ET112 setup? @PsyWulf the "CBI ASTUTE" does it tell you the max amps achieved ? I really need to know #1 How close & #2 at what time of the day am i close to popping my 60AMP breaker.

*Please note I have changed the Topic description Good day All, I'm very new to this. I'm looking for device that will allow me to pull logs. Specifically Amp's. I have seen devices that can give historical logs in kWh but that won't help me. I need to know what is the max Amp's pulled on which day of the week and what hour of the day What is on the market,what are you guys using? Recommendations please Regards

Douw pop me a msg on what's app quick 0/7/2/2/14/6/7/1/5

Good Morning All, This is my first 48v inverter install. I have the SOL-I-AX-5M4 / Mecer 5.6kw 6kwmppt 48v unit. My inverter runs foperfect for 10 minutes, then gives a error 61 code reboots then runs again for 10 minutes error 61 and so on... So my understand with this thread is #1 that you can by pass the error 61 code by running it in user defined mode? #2 Get the correct wiring cable... There was alot of talk about firm ware versions and also I think there might be a compatibility issue with the battery and inverter. (Works fine with a 2000 battery but NOT tye 3000)Please see my pic and advise accordingly. Currently I'm using the ethernet cable marked "Axpert inverter -> battery" is this the correct cable for comms on my unit or must I use the RS-485 cable