jetlee

I used an old straight through cable, and it was wired as follows
Orange (pin 2) -> A / D+
Green and White (pin 3) -> B / D-

I didnt search for the files, when it was unrecognized, I just told it to search online for a driver and it installed no problem

OK, had a minute so git my wife to release her laptop
driver : ftdi (2.12.36.4) (2021/07/05)
driver files
ftser2k.sys, serenum.sys, ftcserco.dll, ftserui2.dll
worked fine with my batt, did a quick software connect to be sure
Hope that helps

Just a note for anyone who finds there way here and has a similar problem with the Narada and the older (5KW) Axperts. The error I was getting was the BMS going into short circuit protection. This is most likely due to the instantaneous current draw when switching powers source if the capacitors discharge slightly. So .. running a single Narada is a bit hit and miss it seems .. probably going to order a second one to get it going properly

Sure .. bought this one https://www.robotics.org.za/RS485-MINI , all the others I found were like 300 rand plus, this one with shipping (95 rand in SA) was still cheaper even with ludicrously expensive (proportionally) shipping .. 
Hooked up to a homemade RJ45 ..
Good luck