Mark Shepherd

No, have not been resetting the batteries. Good idea. I will follow these instructions and let you know. Many Thanks

Thanks a lot jumper. I changed the dipswitches as you suggested and the battery bank went from 200ah to 50ah. Reverted.... What I just noticed on the luxpower web interface is that the primary inverter is BattParallelNum 4 and the 2 subordinates are BattParallelNum 0. See attached.

Thanks mzezman. I have studied that video previously. My inverter setup, I believe, is correct. Certainly, if I change a parameter on the master inverter, it changes it on the other 2. Also % load seems fairly balanced.

Thanks NeilJ. Valid consideration, but no, not removing the dongles ever.

Ah. Yes, Lithium selected. But using option 8. Last time I selected option 2, battery bank wasn't recognized. A side issue, but possibly related.....is there a way of keeping 1 of the 3 inverters as master. Also, must the CAN cable be plugged to the master inverter? Each time I have an issue and the inverters go off or are switched off, I end up with a different master, regardless of power on order.

Thanks a lot for your input. Yes, connected via CAN batt side pin 4 to inverter side pin 4 and batt side pin 5 to inverter side pin 3. No other pins connected.

I have the same issue. 4 x SDA10-48100 connected to 3 x Luxpower SNA5000 inverters. Total AH reported is 200. I've double checked battery dip switches and RS485 connections, B to A etc. I've made up the CAN cable as per the manual. Any suggestions?

I have 4 of these batteries in parallel, but the Luxpower inverters only see it as 200ah. My dip switches are as follows: battery1-5&6, battery2-1, battery3-2, battery4-1&2 Battery1 has a cable from can port to master inverter. Battery1 - RS485 portB to battery2 portA. Battery2 - RS485 portB to battery3 portA. Battery3 - RS485 portB to battery4 portA. Any help would be greatly appreciated