Prash

@Coulomb is there a software tool I could use to copy firmware from both these RCT inverters that would allow me to update the older one and send both versions to you to possibly review for parallelability?

Thank you Coulomb, appreciate the response. I've been trying to query this with Voltronics with no luck.

Hi All Need some advice on parallel connecting 2 Axpert inverters together. I have a Mecer and 2x RCT. Can I connect them in the combinations shown on the pictures linked below? https://imgbox.com/pyx2eRpD https://imgbox.com/EUNIAbgV

Hi everyone. Newly registered member but have been browsing the forum for a while now, learning from you all (thank you). I need a little bit of advice on wiring please. I looked through the topics but could not find something simplistic that explains specifically what to do about grounding, avoiding grounding loops and keeping partial loads (stove, geysers) direct on utility (also did not want to hijack someones thread). Illustrated below is what I intend on doing but want to check up on a few things first, 1. Do I have the wiring correct? 2. What about the cabinet grounding, with the battery grounded to the cabinet but the inverter grounded from the grounding bar? 3. What do I do with the output ground from the inverter? 4. Is it correct/required to keep the output neutral completely separate from all neutrals before the inverter? Ignore the changeover switch required in case of inverter failure. Thank you for the support, much appreciated. Prash.