Sam C

Good morning All System is working but struggling with comms between batteries and inverter. I have coupled two batteries with straight Ethernet cable between RS485 interconnect ports, set battery dip switches to master=1, slave=2, ran supplied cable (pic attached) between master battery second RS485 port to inverter, connected CAN cable from inverter (2-wire) to master battery but still fail to read battery status from inverter. Any guidance would be greatly appreciated, thank you.

Hi Guys Can anybody guide me to comms between Deye 8kW (SUN-8K-SG01LP1-EU) and 2x Averge LfeLi-48100S batteries please? Cables required, DIP switch settings and good software to use for system monitoring. Does one manually need to set percentages for cut, restart, etc. Much appreciated guys.

Thanks @reapster, will definitely check this one out

Thank you. Any free software available?

Good morning All Has anybody done setup of Mecer (Axpert) SOL-I-AX-5VP inverter with RS232 comms via Raspberry Pi in order to access inverter over Ethernet/Wi-Fi network. Any guidance would be appreciated.

Many thanks for your invaluable input Sir, it is much appreciated.

Good morning All Total noob here. I have had a Mecer (Axpert, I believe) SOL-I-AX-5VP inverter installed along with two Averge LFeLi-48100S batteries in parallel. Any guidance on getting comms setup: between batteries (I believe just straight RJ45 cable between the RJ485B and C ports between the two batteries) (DIP switch two "ON" on second battery?) between the main battery (DIP switch one on) and the inverter (inverter has one RJ45 port and one USB-B port) between the inverter and network for remote monitoring on PC with Watch Power or similar Many thanks in advance. IMG-8848.bmp IMG-8881.bmp