Carel.Rossouw

It is fine I’m also learning something new.

This was pulled of from SMH. Some of the first batteries was 2021

This is my time that my geyser is on. It is a 200l 4kw geyser that is mounted outside under the roof overhang in a closed corner. Between 12:00 and 16:00 i’m using the pv to charges. my batteries is starting to drop in ah i have 4 Narada 48npfc100 the oldest one is on 111 then two is 91ah and one of the latest batteries is on 30 ah. I want to first upgrade my battery bank before i wil go lower in the discharge. I have switched off that one with 30ah it feels that that batterie is pulling down the rest of the bank. I also want to upgrade my panels up to 600w-650w per panels i think that i will be able to use the old structure but that wil only be after the batteries.

I'm heating it up sometimes we shower early other times we do later. on the battery i dont want to drop them to low i first wat to upgrade the batteries before dropping them so low.

This is from my Sunsynk app, hope this will work.

On this stages I have 24 x 310 w panels 18 of them is at an angle of + -20 degrees the other 6 is close to flat on a carport roof. All of them is facing north. I have 4 100Ah Narada batteries that i want to try and sell to buy 4 new Greenrich 6.1kwh batteries, and maybe add an extra 2 on a later stages. We use gas kettle after 16:00 and don't have any other high power equipment after 18:00. I live in Secunda i think we have some of the sidewalk trees that have shade over the panels, I'm busy to get our municipality to cut them.

Good evening. I want to find out what id the best way of saving cost on water heating. On this stage I'm using a cbi smart timer to only switch the geyser on and off, I'm also using a Sunsynk inverter to power my geyser 12:00 to 16:00 when the batteries is full to have warm water for dish washing and handwashing. Our schedule is of a kind that i need to heat the geyser between 19:00 till 22:00 in the evenings and 04:00 till 07:00 in the morning. We are using 20 units per day. What is the solutions that is available to do?

Good evening. I have a 20l gasmate that is installed. I want to find out what the difference is between the two temp settings. When we open a tap in the kitchen bathroom basin the water temp is luke warm then drops to cool then lifts a bit then drops down to cool. What can that be?

Good day i want to find out what is the best battery that works and communicates with the Sunsynk inverters. What is also a good reliable battery to use with that inverter. Regards Carel