Jump to content

JAS1

Members
  • Posts

    7
  • Joined

  • Last visited

JAS1's Achievements

  1. JAS1

    Axpert problem

    Good day all Thank you all for the feedback. No imbalance in battery voltage, it is within .1V from each I just think i bought (although new) low quality batteries. Just another question, can one connect 6 x 200Ah AGM batteries(wired so that it deliver 24V) to the inverter and expect it to keep it fully charged. Take note i only use utility power and not Solar panels. The AC Charger mode reads the following on the inverter: AC Input:230AC,50Hz,17.7A DC Output :27VDC,30A/20A AC Output:230VAC,50Hz,13A
  2. JAS1

    Axpert problem

    I also forget to mention....The cable from the batteries to inverter, I use as per spesicfication 22sq mm Cable,however both the positive and the negative cable goes through a 100A DC circuit breaker...could that maybe have a effect .
  3. JAS1

    Axpert problem

    I mean no pv panels
  4. JAS1

    Axpert problem

    I have a new 3kva 24v inverter.reading through this forum,i am pretty sure that all the settings are correct.I only use it to power during load shedding a DSTV explorer,2x routers,1xflatscreen tv and maybe a 5w led light.The display when selected show in total less than 25% load in fact 175 watt with 6A discharging current,i use 2x 12v /120ah gel batteries(new) in series.My problem is it only supply power for 1 hour then code 4 comes on that means low battery power.And yes i have measured it with my multimeter and the batteries indeed measure =cut-off- voltage 21V .I have tested it with just the decoder and 2x routers on with tv off and no 5watt led light,just 1 hour and the same happen.Is there any body that experienced the same....would appreciate your comments and myane some sort of direction.I cannot believe that the batteries are faulty,what else could it be?
  5. JAS1

    Jas1

    I have a axpert 3kva inverter with 2x12V 120ah gel batteries in serie,i only supply power to TV,DSTV explorer and 2 x router = 179 watt in total,regardless if i power up a 5w led light alone or all the above,after 1 hour inverter shows error “4” which means low battery power,all the equipment including the batteries is brand new,any suggestions what the problem could be?I am positive that all settings are correct.(but you never now)help please!And yes the batteries are fully charged once i change over to inverter during load sheding,and after the inverter cut off i measured the voltage of the batteries = 21V which is correct and set to cut off,it seams that the batteries drain very fast.
  6. JAS1

    Jas1

    I have a axpert 3kva inverter with 2x12V 120ah gel batteries in serie,i only supply power to TV,DSTV explorer and 2 x router = 179 watt in total,regardless if i power up a 5w led light alone or all the above,after 1 hour inverter shows error “4” which means low battery power,all the equipment including the batteries is brand new,any suggestions what the problem could be?I am positive that all settings are correct.(but you never now)help please!And yes the batteries are fully charged once i change over to inverter during load sheding,and after the inverter cut off i measured the voltage of the batteries = 21V which is correct and set to cut off,it seams that the batteries drain very fast.
×
×
  • Create New...