BillC

Thanks for the advice. Can't see Airtime Fairness on my TP link router...at the moment everything is working well and hasn't dropped out so I'm holding thumbs

Thanks for the feedback. Solid advice..😀 will try it as even my home laptop is jumping between my router and the extender !!

Hi All, Many thanks for your advice and suggestions. Unfortunately the dedicated network cable is not a starter as my router is too far away from the Pi device. I had a thought that I might try to replicate the WiFi dropping out by switching off both my Router and Extender - simultaneously and separately. When the Wifi then restored itself, access to SA was instant and available. Didn't have to restart the Pi device !! So, I am not sure if that proves that the "connectivity" is not an issue..and points to the Pi Device itself..currently everything going well with the system Kalahari Meerkat - I need to get my head around what a shell script via cron can do for me and if this reboot can be done remotely (via phone preferably)

Hi there, Every week or so I lose Internet connectivity to my solar system (Orange Pi) System is fine but just internet access goes off. I have a standard router upstairs with a wifi Extender closer to the kitchen pantry downstairs. Reasonable connectivity but extender was required. The router and extender are on the same Wifi Channel 4. No neighbours on similar wifi channels. As soon as I reset the unit (turn off/on) everything is back to normal but is irritating when I'm travelling to monitor my system. Any suggestions Please...

After tripping my Inverter recently, I rebooted inverter/battery/mains/raspberry unit. Since then my battery is showing around 21% whilst my inverter shows a "full" a battery (and stops charging) at 54.4V Any ideas how I can reset so it shows the correct % or shouldn't I worry about it ? Thanks

Hi TheoFarm, Many thanks for the information. The manual photo looks different from mine and could be the later version of the Probenergy Battery they brought into SA. That said, we have managed to get Solar Assistant working by using the Voltronic cable https://solar-assistant.io/shop/products/voltronic_rs232 with some minor pin in/out configuration changes. My installer did the modifications so I am not quite sure of the detail behind the changes. Either way we are now up and running !! Appreciate you sending the documentation 🙂

Hi there, Can anyone assist with the details of the type of "Battery Management System" of the PROBENERGY in their 4.8kWh Battery "Embedded BMS for optimal performance and safety" YS-48-100-W Probenergy (1).pdf