JpRoux

Hey man,
so story short from my side. I decided to let go of the Hubble and replaced it with a dyness. Was literally plug and play without any issues.
 
if you having issues, speak to the installer they should have access to the LuxPower group to provide feedback. 
 
I would also recommend updating the firmware on the inverter. But preferably let the installer complete it :)

@Burtthanks for the heads-up. Mine is already set with the above. However, only charges until 86%

Thanks Burt. Let me direct message you.
current charging by time. 

Ok so i thought id add this on here as a few people asked , 
Note that this seems to be working for me , your milage may vary , 
If you do make the changes , please let me know how it's working for you and if you pick up any inconsistencies,
Do note , I've only had my inverter since 28 September 2022 , So I'm still very new to this , and running the system with the "New configuration\Settings" since yesterday only.  
 
My Setup is as follows , 
1 X LuxPower SNA5000WPV
1 X Dyness B3 
1 X Can\Comms Cable  
 
a Screengrab from my interface this morning , 

 
5 Min Later 

 
It Looks like it doesn't dip below 100% on the SOC from what i can see, 
Whether this bad for the battery i am unsure , Hopefully someone on this Forum can comment , 
 
As for the settings , the SOC and Voltage based charging does work , 
On SOC however it will only start charging once your battery dips below 90% (Available) , "-10%(Used)" , and will charge back up to whatever you set it to , 
My issue with this however is , you wont always have 100% battery available , again , not sure if having 100% available all the time is good, bad or doesn't matter. 
 
The Settings i use is as follows . 

 
 
Please keep me posted on how it works out for you , Or if there is someone out there with better ideas \ suggestions \ settings \ advice , 

lol Also new here , so in same boat .