xamillion

I set the value of parameter 60 - Low DC cut off voltage or SOC percentage on second output (L2) to 45 volts, so that the second output would be switched off when the voltage drops below this value. However, this does not happen - the second output remains on even when the battery voltage drops below 45 volts. Any idea why this is so? Current firmware versions: Main Board MCU Ver. - 60.07 Remote Panel Ver. - 39.17

Hi, thank you for your help. I will try to update the following way: Main Board MCU Ver. 60.07 -> 60.95 Remote Panel Ver. 39.17 -> 39.26

Hi, thank you for your help. I see that the Wi-Fi Module successfully connected to Wi-Fi but I guess the problem is between Inveter and the Wi-Fi Module. Even the Wi-Fi icon is not visible on the invertor's display.

Hello everyone! I use SILA IV 6000MHT (TWIN) inverter (https://e-solarpower.ru/solar/inverter/hybrid-inv/gibridnyy-solnechnyy-invertor-sila-iv-6000mht-twin/). It looks similar to Axpert VM 4 TWIN 4KVA/6KVA (https://voltronicpower.com/en-US/Product/Detail/-Axpert-VM-4-TWIN-4KVA-6KVA). From the factory, it came with the firmware: Main Board MCU Ver. 56.09 Remote Panel Ver. 39.06 Then I updated the inverter with the following firmware from the seller: Main Board MCU Ver. 60.07 Remote Panel Ver. 39.17 I searched through the forum and found that there is firmware with intelligent fan control. Could anyone advise what firmware should I use to be on the safe side (Main Board MCU and Remote Panel)? Another question is regarding WatchPower app. For some reason inverter stopped sending data to the app installed on smartphone (it shows gray icon instead of green). Although WatchPower software installed on the PC and directly connected to the inverter with the cable works properly. Is there any way to restart the inverter module without powering down the whole inverter?