Burt

All the Settings on my side from Luxpower remote management portal. 


 
Firmware available from App - 

Hour after loadshedding...and its charging back up to 100% it appears.
Will keep monitoring, still need to figure out this 100% charge/discharging cut off.
Set according to time and letting the battery BMS do it's job

Thanks 
 

Yeah, was stressing on the 100%, so I brought it down slightly...as a buffer. Will check after load shedding to see if it recharges back up again. Set it to Time now, so it went up to 100% and is sitting there with minor discharging and recharging going on for now. Thanks for all your guidance buddy.

Hi , 
Let me know how it goes , 
I also see that your "AC Charge End Battery SOC% is set to" 98% 
Maybe try setting that to 100% ? 
Else from what i understand the Battery will stop charging @ 98% , Unless you have a reason for it set to that ? 

This was my Battery status (Voltage) over the last few days , 
 

Thanks Gents, I'm  struggling with the same....charges and discharges even if Grid is available. Will try out the time settings without SOC. This is my current setup with SOC

All the Settings on my side from Luxpower remote management portal. 


 
Firmware available from App - 

Thanks Burt. Let me direct message you.
current charging by time. 

Greeting. I am new to the forum. Also having the same problem. Battery will not maintain voltage after charge
 

@Burt, check your DM's. I sent you a msg
 
 

Ok so i thought id add this on here as a few people asked , 
Note that this seems to be working for me , your milage may vary , 
If you do make the changes , please let me know how it's working for you and if you pick up any inconsistencies,
Do note , I've only had my inverter since 28 September 2022 , So I'm still very new to this , and running the system with the "New configuration\Settings" since yesterday only.  
 
My Setup is as follows , 
1 X LuxPower SNA5000WPV
1 X Dyness B3 
1 X Can\Comms Cable  
 
a Screengrab from my interface this morning , 

 
5 Min Later 

 
It Looks like it doesn't dip below 100% on the SOC from what i can see, 
Whether this bad for the battery i am unsure , Hopefully someone on this Forum can comment , 
 
As for the settings , the SOC and Voltage based charging does work , 
On SOC however it will only start charging once your battery dips below 90% (Available) , "-10%(Used)" , and will charge back up to whatever you set it to , 
My issue with this however is , you wont always have 100% battery available , again , not sure if having 100% available all the time is good, bad or doesn't matter. 
 
The Settings i use is as follows . 

 
 
Please keep me posted on how it works out for you , Or if there is someone out there with better ideas \ suggestions \ settings \ advice , 

lol Also new here , so in same boat .