Craig Pottinger

Evening, Has anyone purchased items from the power forum store? I am struggling to see if items are in stock or not. Would like to know before making payment (60K). Have tried calling and emailing. No response.

Does anyone know where to setup the push notifications for the new Sunsynk Data logger. Website says it has this feature. But can't find it anywhere.

I had the same issue with the 150ah narada batteries. Your values seem too high. Was told the safer settings are. Float 52.5 Absorbtion 53 Equilization 53. They are working on a firmware update.

Just for your info. Spoke to Sunsynk. There is definetly a communication problem between Sunsynk BMS and the Narada BMS. Apparantly they are working on trying to resolve the problem. Have to use AGM Voltage settings in the mean time.

Thanks. My settings are as above. If you have a look at the sunsynk compatibility list.it says that batteries will be controlled via the voltage base settings. For some reason I dont think the inverter ia "seeing" the battery bank. Going to buy another rs485 cable today. Hopefully its that.

Hi Guys. I Just installed a 8kw Sunsynk with 4 x 7.2kw Narada batteries. The batteries have there own BMS with digital display. All four batteries show 100% state of charge. But the Sunsynk has it at 51% SOC and is charging the batteries. The menu on the batteries also show status as charging. (10 amps). Worried that if I continue charging the batteries they could get over charged and damaged. Have setup the Sunsynk as follows: Float Charge: 54v Bulk charge 54v Equilization 54.1V These are from the Narada manual. I am using the Rs485 port on sunsynk and battery. Any advice would be appreciated.

<Hi. As far as I'm aware. If you set it up without a battery. You only connect the mains power to Grid. Nothing can run via Load. It becomes Grid tied. CT coil must be on Eskom side. Arrow facing towards the inverter. Hope this makes sense.