Lukas

Problem found. Any thoughts were i can get a replacement seems like scc board for axpert 5mks?

Thank you…. Still same issue

Apology OSO

Hi settings ar 01 sol 02 50 11 2A 12 44 13 54 16 sol 26 58,4 27 54 29 42 thank you

Thank you for the feedback. Tried as proposed but problem persists. Even ‘reupdated the firmware’ with same result. Any other possible options?

also not sure what the "pi"5 symbol is???

Morning everybody, I had to move my inverter and when switched on again the inverter wont charge the batteries. Does not seem to pick up the panels? Any thoughts please? thank you. The setup is 2x460(+-) W panels in series, two strings in parallel ie 4 panels. Nothing else has changed....... which is confusing....

I have a similar question, was looking at Pylontech up5000 4.8kWh Li-Ion solar battery 48V, but not sure if the Axpert will charge it correctly?

Thank you Chris. Zero'd and works perfectly out of the box. Pitty watching useful battery capacity go to waste though.

Hi. We installed an Axpert 5kVA inverter (offgrid setup). After adding a BMV702 realized the axpert uses 65W with absolutely no load attached other than itself. This seems excessive, or is it correct? Any thoughts or similar experience