Harry Khiani

if i am right the remote control feature is exclusive to distributors and they have to be approved by deye on the solarman business platform.

Since we are at it I have been noticing that my loads that are on the non critical load starts taking power from grid when I do have enough pv to feed all loads. Why would that be.

The ct coils use 3456 ports . And please bear in mind that the arrows on the CT sensors should face the grid I use a split phase so I guess that's why I need to use 4 ports

My current setup I have 16 430w Canadian solar on one pv and the next pv is 255w 20 panels. I have enough generation . I have a deye 8k inverter what I have been noticing is that inspire of it being a bright sunny day when I switch on loads it takes from pv and grid. When I truly know that thevpv can support the full load . Attaching some images

Good Afternoon Members, I have installed 2 inverters in parallel in a commercial supermarket i have done 2 projects. But these are the errors coming up of recent. Its 2 DEYE 8k INverters which is same as sunsynk. please give me your suggestions. the f18 is very frequent and what happens when this error comes is there is a blackout for some time and it comes back. Any help would highly be appreciated.

Kindly help me doing a new installation and have paralleled 2 deye 5k inverters. Getting a F01 error which the manual says "dc_inversed_failure" what could be causing that

Yes i do

Hello Members, Let me give you'll a run through of my system setup pardon me if i sound novice. i have a main panel and a critical load panel. My CT sensors from the deye 8kw inverter is connected to the Main AC line coming into my home ( I did this so i during the day i can choose the option of ZERO TO CT and feed my non critical load too). Yesterday we had a couple seconds power outage in the area and i had a black out and the inverter gave an error code of F18 which states AC OVERCURRENT . i manually changed over to Grid via the changeover switch. After a couple minutes the error beeping went off i switched back to dc power. Any reason why this could have happened. What should i do to avoid this error in the future.

Hello Members, I am new to this forum. I have 8kw deye inverter (same as sunsynk) i would like to find out if anyone was successful in using the lithium mode. I use a GSL Powerwall LIfe po4 battery 200ah. Any Help will highly be appreciated.