ishtiaq

having the same issue with Deye 8k and 4 pylontech UF5000 experiencing over charge on combine charge grid and solar, firmware update by deye but the issue still there, no noting solar and CT export is disabled any advice on this issue ishtiaq

I had gone through long search on the dip switch configuration was getting different feedback form different technicians, pylon support not giving any cleay answer on the issue instated keep sending the user manual which did not help at all finally I reached a youtube channel and they were very kind advising. Dip switch configuration please see below : System 1 : 4* UF5000 Inverter Deye 8k Dip Switch all off System 2: 3* US5000 Inverter Solis 8K Dip Switch all off hope this help ishitaq Hello, The DIP settings for both of these systems will be all off. The PylonTechs do not rely on the dip switch settings for normal operation. Thanks, Michael King (406)-880-5952 https://intelligentcontrols.io/ youtube.com/@intelligentcontrols

Midnight getting 37 volt on the panels CB is this okay ??

hello how to sort out leakage from battery, is this could happed with lithium batteries as well, kindly advice

im getting 37 volt at night got 9 panels 375wat connected in series, need help how to sort this issue, system info: 4* UF5000 Pylontech 1* Sun Deye 8kva DC breaker 63am tanks for advice

hello im getting different feedback on dip switch including pylontech distributor's site engineer, what do you think ? note the following: bat 1 pin 1 on 2-4 0ff rest of the battires all of the setup aligns some pylontec configuration where the master battery has a distinct setting, and slaves follow a uniform setting thank you your advice in this matter ishtiaq

Dear All I am writing to report a critical overvoltage issue in my solar energy storage system and request urgent technical assistance. System Configuration: Batteries: 4x PylonTech US5000 (parallel connection, CAN protocol). Inverter: Deye SUN-8K-SG01HP2-US-AM2. Communication: CAN/BMS protocol enabled, no explicit errors logged. Issue Description: During charging, the battery via grid voltage spiked to 56.94V, exceeding the US5000’s maximum safe limit (53.5V - 56.80). The Deye inverter halted charging automatically during the event. No communication errors or overcharge alerts were reported by the inverter. Troubleshooting Steps Taken: Verified inverter settings: Charging voltage limited to 53.5V - 56.80 (PylonTech lithium profile). CAN protocol confirmed active. Addresses set correctly (1–4) for parallel configuration. Tested communication cables Request: Please provide guidance to: Diagnose potential BMS or communication failures. Thank you for your urgent attention to this safety-critical matter.

facing same issue got luminous inverter 6KW with 3 * US5000 pylon the reading is crazy

hello with regards to dip switch its still confusion this what i have: 4 bat pylon UF5000, using can cable Bat 1 pin 1 one bat 2 pin 2 one bat 3 pin 2&3 bat 4 pin 2 kindly advise if this is correct omer

hello can any one please advice what the charging current @35c Bulk and absorption for Narada 313 12V 200Ah regards ishtiaq