Flipster

Hi, do you still have the inverter or has it been sold? Also, do you have the faulty mppt controller? And lastly, you don’t by any chance have the data bridge unit? Regards Flip 0723007564

I have the same issue. Any ideas anyone?

I would like to know if there is a way to remotely switch my Kodak inverter on or off via the ICC / pi combination? It’s a completely off grid setup. Sometimes my batteries run out, and the inverter switches off with error 4. I then need to physically go push the round button to start it up again. I would like to do that remotely. If the inverter shuts down the ac output, the charging circuit still runs to recharge the batteries. It is just such a mission to drive out to the site to go switch it on again. There has to be a better way. I did loom at the remote button pushers - but I have to import that from the states. Any advice will be appreciated.

Hi Powerforumnators I have a new Kodak VMiii cheese box that seems to work great except for one thing: The darn bluetooth. I cannot pick up the darn thing via Bloopoof. Any suggestions / advise / help? Please!! Flipster

Can anyone help me, I cannot even connect via bluetooth. No device shows up in my list of devices to connect to. I cannot see the inverter per say. The Bluetooth icon is on on the display. What am I doing wrong?

Hi, do I understand this correctly, the battery does not need a firmware update only the inverter (I have a Kadak VMIII), IF it is older than firmware ver: SBU firmware 02.49? Or can I download the latest firmware and flash the battery myself? Which firmware should the battery have so the the BMS will work as described above in this thread?

Did anyone solve this issue? I have exactly the same problem