Namreh

Yes, 53.8v is correct

Hi, I have not realy played around with the timers as such. I had a issue wher I installed a MAX II at a client, but he is happy the way its runs now

Thanks, they only have 3 wire units. I ended up ordering from China.

Hi, I am looking for replacement fans for axpert 5kva inverter. It is a 12 volt 0.3 amp 4 wire fan 80x80mm Thanks

Hi, I am also looking for replacement fans for axpert 5kva inverter. It is a 12 volt 0.3 amp 4 wire fan 80x80mm Thanks

Anyone using Enersol lithium battery with any feedback perhaps?

Thanks all

I have the older type Axpert inverter 5KVA/4KW connected to Solar Assistant via the USB -B connector Using gel batteries currently. I want to upgrade to a Hubble AM2 battery. Can the BMS of the Hubble be connected to the solar assistant to get full comms or do I need a Hubble cloud link to achieve comms?

Hi, is this in the custom settings as when you connect the BMS it seems to override all settings

Seems like the BMS is taken over the settings. Even though the Pylontech shows 53.5v for cv voltage it seems to end at around 51.3 volt. Even the amp settings is overrides to 10 amp only. Will test it as is as the BMS should control this correctly anyway.

Thanks for the reply. In the inverter setting under lithium they have a few brands like Weco Pylontech etc. I will check if there is a custom setting under lithium perhaps

Hi all, Assistance needed for the correct settings for a Dyness B4850 with a RCT AXMK 4 3.6KW inverter. I found some info that Pylontech settings to be used but it seems that the voltage go up to 53.5v with the setting. Other info states 52volt for cv and 51volt for float. Battery and inverter do communicate. Thanks

Agree, I have Solar Assistant on one of my other units and they work flawlessly. Not sure but since I installed the Cloudlink my SOC issues is sorted

Just an update. Since the Cloudlink installation SOC is all sorted. Not sure if Hubble perhaps upgraded the firmware.

I have the same issue