Jump to content

AntonDj

Members
  • Posts

    17
  • Joined

  • Last visited

Everything posted by AntonDj

  1. You cant say no to my request and in the same sentence tell me you will provide best service. I will still have to waste my time effort and money to make Dyness work.
  2. I am pretty sure if i can upgrade a battery if i can program and upgrade firmware on swithes and firewalls. This battery will be no challenge. I have tried to contact them many times. They took 30 days to reply. Then more than a week. I have sent email once again to repairs supervisor Werner Bezuidenhout on 28/07/21 again no response. Good luck reaching them on phone and getting hold of him. Tried many times. Expanding on Dyness and buying instead of Pylontech does not seem viable in South Africa. Especially if this is the level of support. Can the procedure and firmware be made available i will take full responsibility.
  3. Hi Can i not do this myself, i have to get an installer to remove the 30kg battery from a 3 meter cabinet and drive 50km to them and then do the same to reinstall which is going to cost a lot of money. I am more than capable of doing the upgrade myself if given the procedure. Please advise.?
  4. Thank You i will check and submit.
  5. Please see my description. I believe it matches yours? My dip swith is 2 on..rest off. Cable battery side pin 1 goes to pin 5 on inverter and pin 3 on batt goes to pin 3 on inverter. Please assist Once i do that communication is lost and it does not charge battery. See attached
  6. Thank you .. I am also not getting communication it seems..as when power goes out battery shows full but inverter immediately reports low batt and shuts off. My dip swith is 2 on..rest off. Cable battery side pin 1 goes to pin 5 on inverter and pin 3 on batt goes to pin 3 on inverter. Please assist
  7. Hi Please see attached..Thanks
  8. I am using a single Dyness B3 with RCT 8kw inverter. Can someone please advise me what is a sensible cut off voltage for this battery. Also need advise on a sensible back to grid voltage. That will sustain battery for as long as possible but still keep me within warranty parameters. Thanking you in advance
  9. Please can anyone assist.. I have an axpert 8kva with one pylontech 3000.. Once on battery alone 49. X my % shows around 98% pic attached. Huis.. However on my second system axpert 8kva with 2 pylontech 3000..ons battery alone 49.x shows my % around 24 %, pic attached Plaas Please if anyone can help me make sense?
  10. Hi Please advise .. where do i see the Module PN no idea what is is or where to get it. Regards A.
  11. Thnx will check maybe add some pics of the setup
  12. Please if anyone can assit. I have Axpert 5Kva connected via BMS unit to Pylontech.. Only change made on Axpert is to change batt type to User.. I am not sure what rest must be. My issue is on Axpert battery shows full but on Pylontech it seems to charge constantly second last light flickering and first light off (Charge indicator). Indicating battery never full. How do i get it to charge fully and sync the two. Any assitance is appreciated. Thanks
×
×
  • Create New...