Johan Kotze

Hi What will be a typical power collection setting. I have 48v hybrid system. 2x Mercer 5.6kva, 2 x 5.1 Hubble AM5 battaries and 24 x 450w panels. My setting currently. Panels plus grid then batteries if grid fails. Program 01, SUb I did test where I switch off eskom main feed in the DB. So then only panels an batteries provide power. At night time I switch eskom back on. Is it better not to switch off eskom and let my current settings do their job? Or what will the best overall settings be in the program setup for a Mecer SOL-I-AX-5M4. Looks like the grid is providing the power or am I reading the display wrong1nn1

Thx for you guys replies. I did check all cabling etc. At the end I called DSTV CALL CENTRE, and they sort the problem out. What they did I really don't but the 2 decoders are working. Wll revert back if they fail again.

Thx Steven87, will check

Good day, I have 2 x Mercer 5.6kv and 2 x 5.1kv Hubble AM5 installed. I have 2 x extraview decoders installed one in main bedroom the other in the binnebraai. Explora in TV Room. All of the above operated perfectly before 12 x 460w panels was installed by the installer. After the panels installation the 2 x decoders is powered but no signal. The Explora works perfectly in the TV Room. When the panels are switch off in the panel box, (only using battery power) the 2 x decoders work perfectly. Did anyone else came across the such a problem.

@zsdethx

@zsde Geewiz delivered the battery balancer but saw that online link to the product is a HA02. The one that was delivered is a HB02. Are there any differences between the two.

@Coulomb I did switch inverter #2 off immediately when I saw F08. So I only run inverter #1 now. Waiting for the electrician to disconnect the battery cables so that I can change 28 to PAR on inverter #1. Then both will be PAR. Then connent the cables again. @BritishRacingGreen It was a disaster first time around. Luckily the supplier replaced the unit.

@Coulomb I did switch inverter #2 off immediately when I saw F08. So I only run inverter #1 now.

@BritishRacingGreen thank you will try tomorrow. F08 is error bus overload

I have 2 Mecer 5m4 connected in parallel. I get a F08 error on inverter #2. Inverter #2 program 28 is set to PAR. But inverter #1 can't change to PAR form SIG in program. Could that be the problem for F08 on inverter #2.

@Scorp007 thx @zsde thx

Must I have 2 battery balancers or is 1 enough as I have 8 batteries.

@zsde thx

I see that there is 2 charging settings 1. Max battery charging current 2. Max AC charging current Should I set point 2 to 50A or both

@zsde Just bought the Balancer from Geewiz