Inverter

Thanks for the reply

Good day What did you people do to resolve the issue? I have a LuxPower inverter with 2x CFE which do the same think

Hi @ShaunH Thanks I am sorted with it the 5 increments is in % Did you ever use setting 99 and 100?

Hi @Jakkie, @Afrikaner Do have any success on your settings I also need advice please?

Good day @SEGEN SOLAR how can I confirm that I have communication between the inverter and the Pylontech batteries? Can you also help me understand what is the function of setting 100 on the OG 10?

What will be the cost for such sisteem? I do have the BMS cable and the inverter is set to PYL which is for Pylontech batteries. At the moment it jub from 45V to 50 and too 55V I didn't see if it go higher or lower.

Hi @Ben Harper I want to use SBU in program 1 and want to adjust 12 to 48v when the grid must take over. In program 12 I want to change the voltage to 48V but increments on the inverter jump with 5V. What must I do to change it to have 1V increments please?

@ShaunH Hope you can assist me I can change the voltage settings in program 12 with 1 volt increments it only changes with 5v increments?

Hi@Ben Harper Hope you can assist I am unable to change the voltage in 1 volt increments it change with 5v increments what could be reason?

@PepSakdoek may I ask how does your end result look like?

@FrancoisSnyman will you please post the graphs per mppt? Voltage, Amps and wattage.

@1ougatthe 13amps is your maksimum operating current and the 17amps is your maksimum fault current. Your solar panels also have these values, make sure you don't go over the inverter values

@LLTHB did you resolved your problem? Have the same thing

@007do you mind to post some graphs of the good performance off mppt 2? What is the best performance on a cool day on mppt no 2?

@Patrick OReilly I in stalled 2x 120mm fans at the bottom on a timer to control the temperature and it works well