May 22, 20224 yr Seems the Assistant does not work at all as intended … I have inverter set to SBU , activated the Maintain battery state of charge setting. Connected Solar Assistant to Management port of Pylontech by RS232 and via USB to the inverter. WHILE the Maintain battery state of charge is active and the primary source is SBU I try to override the power source for x amount of time and set it to Solar First.. After this the inverter SHOULD return to SBU … but it does not ??? Or I understood wrong this setting ? Here the video : https://youtu.be/vUwtvxC6wP4
May 22, 20224 yr Hi Jaxone, depends on a lot of variables and maybe we don't have all the information on your problem. There is a reason the inverter won't go back to SBU mode. One such reason is because it depends on the back to battery discharge setting on the menu of the inverter. If the battery voltage is not above this threshold, the SBU mode will not activate. After the X amount of time, compare the battery voltage to the setting and you might find this to be an issue.
May 22, 20224 yr Author The batteries are 100% charged and Solar Assist is seeing them as fully charged also. If I manually switch to SBU it will switch without a problem.
May 22, 20224 yr Have you been in contact with SA? Perhaps discuss your perceived problem with them [email protected]
May 23, 20224 yr 12 hours ago, zsde said: Have you been in contact with SA? Perhaps discuss your perceived problem with them [email protected] Report the issue to SA. They are pretty good at getting back to you and getting things sorted. MdF
May 23, 20224 yr Author I did reported the bug , I am just curious if anyone else has this issue. Had same issue with older versions of SA also. Tested the same functionality with MultiSIBControl and that one seems to work as intended.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.