Jazzy

Sorry guys was busy with lots of stuff... So it works, I did come up with a battery alarm fault, quick fix, I merely dropped my volts from say 53.3 to 52.9, and it did not have an issue since then, running 3000 x4, 3000c x1 and UP5000....so it works and thank you all for your input, greatly appreciated...always make certain the new battery is the "MASTER"

I lately installed a US3000C on 4 US3000, they have worked well together and this afternoon I got the red alarm light, with a SYSEr on my SMH for the US3000C battery, is there a place that I can go to, so they may update my firmware...? I merely rebooted everything and it seems fine for now...please let me know whom can, I am willing to pay for it. .

Guys merely asking can we mix pylontech Us3000b with UP 5000s? Merely asking...

I dont know how to say this you are amazing and you are a god sent, it's me I just installed a new 5000w mercer and followed your instructions and voila done, both up and running, it takes about 45 seconds to die after turning off the switch. Thank you, let me know if I can be of assistance.... Thanks greatly appreciated...

May someone let me know if I might have issues please.

You guys are getting me very worried, that is my model I purchased in 2019, managed to find the axact model in the week, will I also have issues with firmware, I am running the PI with SMH, running the Pykontech BMS.

Hi the new gas geyser allows you to connect your electric geyser outlet straight into it....if it senses that the geyser water is hot, gas does not operate, if it senses water is below the gas geysers set 45 degrees, the gas geyser automatically switches on...I agree best investment I made before solar was a gas geyser...good suggestion. Today I am lucky if my account is 35 rand...lol

I have also seen a drop is AMPS, I think this is normal. One must be worried when it drops by 20 to 50 percent. A few here and there is because of the climate I think. Running 4 US 3000B and they don't shiver and shake, standing strong.

Yes it will, cos tour voltage will peak.

Sounds like those two batteries need a hard reset by the reseller.

Did you get the RP with the special cable, and do you have your USB cable to the Axpert inverter, also don't forget to go into settings in the ICC and make the software control the pylontech, this ignores anything from your inverter.

Yes you will, cos the revov batteries come with an external BMS, you will be able to add another battery. However you will be limited to 5000 as your inverter will only go that far, as long as you don't go over 5000 with your inverter, you can have lots of power with two revov batteries.

Hi you are running two batteries only, word of advice you need to add one more. You are sweating the batteries, also I've seen in a configuration of 2 they tend to lose amps. Best is to invest in one more battery, so that when you need cranking amps you will have it on demand.

I think it moves around the gel in the battery there is term for it...slipped my mind. I am running gel batteries AllGrand, and bulk charge at 58.8 volts, float charge at 54.4, and dod is at 44 volts. User set up... I have chosen SBU, and run my pool pump and geyser of it with 12 panels, and two strings 150 AH, 48 volt set up...thus far I have managed to stay of the grid for 22 hours, two hours is just to keep the electricity company going... Will be going Lithium PylonTech 9 KWH set up... Busy testing the difference in all of these things...