Revnge_SevnFold

read the rest of the thread. Download link were shared.

Thank you very much! You guys helped me a lot. Was wondering wth was going on as I was constantly getting low voltage warning light on 80% SOC on my multiplus II.

I suggest stay away from nenergy batteries. Build quality is good but absolutely zero support for software and inverter compatibility/settings are a nightmare to figure out.

I understand, but I can fill it with sikaflex to stop any chaffing and cables are double insulated and fixed to the rails under the panels so no movement possible. 🤷‍♂️

This was my solution. We'll see if this is good enough for COC. Will be underneath the solar panel.

@RiaanC only way I could get software to detect the battery is with all the dip switch's down. I have two of these batteries and I'm trying to validate if the parallel communication is working, but the software will only show one battery at a time... That addressing does nothing, i have played with that it to no effect. I am not sure what the issue could be with the setting. I used pin 1,2,3 on my cable. I am thinking of just replacing these BMS's with JK BMS and adding a 16th Battey cell.

@MightyDee That is strange. I did not. It might be related to decimal formatting. I saw something related to that in the seplos software installation guide/manual. my settings below:

I also have a Victron MPPT. Do you have any more clarity on this subject that you could share? This was also a interesting discussion on the same topic:

@TaliaB Thank you very much for the feedback!

@WannabeSolarSparky thank you for the feedback! I found the instructions for my inverter. You don't know of any of the other devices like i mentioned earlier(power meter, Main DB, sub dbs, trunking)?

Hello guys, I am trying to see where I can mount my inverter to its permanent location. Are there any clearance regulations that I should be aware of when you have limited space? For example, clearance from power meter, Main DB, sub dbs, trunking or other installation related devices? Any assistance would be greatly appreciated.

This is so cool! I can see the balancing happening as well!!

@Neurik Where on earth did you find this software??? IT WORKED!!! I tried the battery monitor from Seplos but that did not work. I cant modify any of the parameters. Like you mentioned with regards to the communication protocals. I see there is a password field, do you know what it is?

@Zombie Do you have a link to the post?

@iiznh Thank you for sharing that project! Honestly appreciated. My next step was to just get a Victron smart shunt for SOC, but lets see if I can get the software working. I owe you beer! 🍻