Hi guys, I just bought a new hubble AM-2 battery and tried to connect them using the CAN ports as follows. My inverter doesnt read any info from the hubble BMS. I made a new cable as per their website here https://www.hubblelithium.co.za/sunsynk-hubble-setup.html with Pin 2 Being a green cable, Pin 4 being Orange and Pin 5 being Blue with still communication. I first used the Yellow cable that came with the deye and had no success and looked on their website and saw that layout.

Any assistance would be appreciated

inverter side

Did you set an "address/dip switch" on the battery?

7 minutes ago, Iiceman said:

Did you set an "address/dip switch" on the battery?

Hi there,

Nope all of them are in the "off" position (all of of them are on the side closest to the numbers)

1 minute ago, TeddyBear said:

Hi there,

Nope all of them are in the "off" position (all of of them are on the side closest to the numbers)

if you only have 1 AM2, then move dipswitch 1 to "ON", rest remain OFF

6 minutes ago, Iiceman said:

if you only have 1 AM2, then move dipswitch 1 to "ON", rest remain OFF

Thank you. I will try this when I get home and relay any updates.

23 hours ago, Iiceman said:

if you only have 1 AM2, then move dipswitch 1 to "ON", rest remain OFF

Hi there. This worked! Thanks so much

16 minutes ago, TeddyBear said:

Hi there. This worked! Thanks so much

No problem, glad its sorted out..

Will it work with a normal network cable from the CAN of the battery to the CAN of the inverter?

15 minutes ago, new2solar said:

Will it work with a normal network cable from the CAN of the battery to the CAN of the inverter?

yes correct, CAN cable is a regular network cable..

Thank you

Hubble confirmed that an ethernet cable works for CAN between Sunsynk and Hubble, but they've found it causes interference and recommend a cable with only pins 2,4 & 5 being used.