Jabu

Hi I have the similar setup, L52.....036. And charge current it sets itself through BMS. Do experience the inverter switch on and off for few seconds and if it reset itself. Or maybe my inverter is faulty

The opening voltage for the mppt was low. I added one PV and opening voltage was then resolved

Good day all, my name is Jabu. Please kindly advice. Is it possible to connect 2 different make of inveters which I have it's a 3,2kva and 3kva 24v solarwize and synerji on single phase. Ornis there any parallel kit can use. Or I can just connect both inverter out put. Is this achievable. My objective is to increase my power to 6,2kva if this can be done. Thank you

Thank you. I will do as your advise

Thats the one. It is flashing and pv generates 135v and and the minimum charge controller is 120v. If l can ask what are advantages of mppt controller. So do I need to add more pv

No Sir. It has its own built-in. On the external one I was thinking if it can be a cheaper option than to buy extra PV or may be I have a problem on my inverter

Good day everyone. Please kindly assist me with my problem. I'm using Solarwize 3.2kva 80A MPPT charge control. MPPT VDC operating is 120 to 450. Normal operating voltage is 240VDC. I have connected 2x455w and 1x445w current specs very close to 445w. I get 134V from my PV. My question or my problem is that my inverter shows the pv on the display, but is flashing not charging. Is my pv voltage low, do I need to add pv, or adding separate MPPT charge controller with lower voltage range. Please advice. Thank you in advance Yours Jabu from springs GP

Good day technical support team. Please kindly advise. What does the regulations say about the size of wire you can use. My inverter is located 13meters away from my DB. Can I use 2,5mm cable instead of 4mm from my DB to the inverter, and from the inverter back to my DB. I won’t be putting too much load, it’s only for lights and 3 plugs. Is 2,5mm cable qualify me to get COC. thank you In advance from Jabu.

Hi. I came across this in this group. One gentleman posted this diagram it has helped me a lot. I hope it will help you too in your question

@plonkster,Thank so much.

@The Terrible Triplett. Thank you so much, I now understand from your explanation. It makes sense now. Thank you

Good day everyone, my name is Jabu. I have been following every conversations here. I have 3KVA hybrid inverter. In the manual it shows that I can 200AH 24V, or 100AH 24V. My question is, can I add or make my current amp AH more than 200AH 24V to 500AH 24V. So I can have more running time without blowing my inverter. Thank you in advance